Specifications

2. Place the ON/OFF/FAN switch in the ON or
FAN position.
3. Verify that the time being displayed on the
appropriate product cooking timer is correct; if
not, proceed as follows.
4. With the timer display at low intensity: (Idle -
not counting down)
ONES — Depress set button "C" with your left-
hand finger and press the corresponding timer
button (1-6) with your right-hand finger. The
right-most digit of the timer display will brighten
and start to rotate through the digits "0" to "9".
To stop the display at the desired digit, release
both buttons. The display will then stop and
retain the setting and return to the idle mode.
TENS — Depress set button "B" with your left
hand finger and press the corresponding timer
channel button (1-6) with your right hand
finger. The left most digit of the timer display
will brighten and start to rotate through the
digits "0" to "9". To stop the display at the
desired digit, release both buttons. The display
will then stop and retain the setting and return
to the idle mode.
OPERATION:
1. Make sure that the power cord is plugged into
the appropriate power supply receptacle.
2. Place the ON/OFF/FAN switch in the ON
position.
3. Verify that the time displayed is correct for the
product cooking timer needed; if not, see
"Setting the Timers."
4. To start a product cooking timer, press the
corresponding timer operation button once.
The digital display will become brighter and a
timing indicator dot will appear and start
blinking in the lower right-hand corner of the
digital display.
The timer will then automatically begin to
countdown. The display will indicate the total
time remaining in cooking cycle.
5. When each timer reaches "00", a three-tone
audible signal will
BE
heard, and the digital
display will blink.
6. To stop a product cooking timer or to cancel
the 3-tone audible signal, press the
corresponding timer operation button once.
TIMER SETTING AND OPERATION
Wells convection ovens have a product cooking
timer as part of the oven control panel. The timer
consists of 6 independent product cooking timers
that can be activated and deactivated independently
of each other by pressing the corresponding timer
operation button on the control panel.
SETTING THE TIMERS (See
Figure 1)
1. Make sure that the power cord is plugged into
the appropriate power supply receptacle.
17
7. The maximum temperature the controller can be
programmed for is 500° F (260 °C), although
the actual oven temperature displayed may
read as high as 600° F (316 °C). If an attempt is
made to program the controller for temperatures
higher than 500° F (260 °C), the controller will
automatically adjust the oven set temperature to
500 °F (260°C).