Specifications

CALIBRATION
Tools: Digital Thermometer with Oven Probe; Oven
Mitt.
1. Be sure the oven is plugged into the appropriate
power supply receptacle.
2. Open the oven door and clamp the oven probe in
the center of the middle rack.
A. Pass the oven probe wire between the door
and the door gasket. Close the door.
B. Plug the oven probe wire into the digital
thermometer.
3. Place the ON/OFF/FAN switch in the ON
position.
4. Allow the oven to warm up for 30 minutes.
NOTE: All product cooking timers must be in the idle
mode (low intensity display) before calibration can
begin.
5. Press and hold the temp button for 10 seconds.
The display should be flashing the word "CAL b".
(See Figure 2)
6. Press the product timer buttons sequentially (1-
6). The temperature display will read "- -" and will
remain that way until Step 8.
7. Note the reading on the digital thermometer when
the heat ON (amber) light goes from ON to OFF.
8. When the heat ON light goes OFF there will be
an audible beep and the temperature display will
record the temperature of the oven at that time.
9. The temperature displayed on the oven should
be within 3°F (1 °C) of the temperature displayed
on the digital thermometer. If the temperatures
are within 3°F (1 °C) calibration check is
complete. If the difference between the
temperatures is greater than 3°F (1 °C) proceed
with Step 10.
10. Use the SET buttons located below the
temperature display (Figure 2) to set the
displayed temperature so that it is the same as
the temperature reading on the digital
thermometer.
11. Use the right-most SET button to increase the
temperature and the left-most SET button to
decrease the temperature (see figure 2). A
maximum of 50° F (33° C) correction can be
made to the original temperature reading.
12. Press the temp button to record the new setting
and to exit the calibration mode.
13. Place the ON/OFF/FAN switch to the OFF
position.
WARNING: Use an oven mitt when unclamping
and removing the oven probe. The oven interior
and probe are HOT.
14. Open the oven door and remove the oven probe.
The digital display will change to the idle mode
(low intensity), the timing indicator dot will turn
OFF and the 3-tone audible signal will be
cancelled.
18
Figure 2