Specifications

2. Using the phillips screwdriver, turn the 2 captive
screws at the upper and lower left-hand side of
the control panel until the panel is released.
Then swing the panel open.
NOTE: The screws will remain with the panel.
3. Disconnect the wire leads from the rear of the
ON/OFF/FAN switch.
4. From the rear of the switch, use the 1/16" (2
mm) flatblade screwdriver and pry the top
flange of the switch upward to release the
switch from the metal bracket. Remove the
metal bracket through the front of the control
panel and the switch from the rear.
5. Reverse the procedure and use the wiring
diagram to install the new ON/OFF/FAN switch.
REPLACEMENT OF THE HIGH-LIMIT
THERMOSTAT (Should be done by a qualified
service person)
Tools: Phillips Head Screwdriver, Flatblade
Screwdriver, 5/16" (8 mm) Nutdriver.
Parts: High-Limit Thermostat.
1. Unplug the power cord.
WARNING: Failure to do so will result in
electrical shock.
Remove the racks and the rack supports from
the oven interior. Remove the interior air baffle
by lifting it at the bottom and pulling it up and
out.
3. Remove the top high-limit thermostat clip by
removing the 2 screws holding it in place. (See
Figure 4)
TOP HIGH-LIMIT THERMOSTAT CLIP
Figure 4
4. Using the phillips screwdriver, turn the 2 captive
screws at the upper and lower left-hand side of
the control panel until the panel is released.
(See Figure 5) Then swing the panel open.
NOTE: The screws will remain with the panel.
5. Disconnect the electrical wires from the
thermostat body and remove the thermostat
body from the supporting bracket. (See Figure
5)
ELECTRICAL WIRES