Specifications

6. Remove the thermostat capillary and bulb from
the inside of the oven and remove the high-limit
thermostat from the oven. (See Figure 5)
NOTE: Adjust the thermostat body on the support
bracket so that the red trip-plunger is centered and
extends 1/8" (3 mm) through the hole in the front
control panel.
7. Reverse the procedure and use the wiring
diagram to install the new high-limit thermostat.
REPLACEMENT OF THE FUSE
Tools: Phillips Head Screwdriver.
Parts: Fuse.
NOTE: A spare fuse is supplied with the oven.
1. Unplug the power cord.
WARNING: Failure to do so will result in
electrical shock.
2. Press and twist off the fuse holder cap located in
the lower left-hand corner of the back panel.
Remove the fuse from the fuse holder cap. (See
Figure 6)
FUSE HOLDER
CAPS
Figure 6
3. Reverse the procedure to install the new fuse.
ADJUSTMENT/REPLACEMENT OF THE DOOR
AJAR SWITCH (Should be done by a qualified
service person)
Tools: Phillips Head Screwdriver, 1/16^ (2 mm)
Flatblade Screwdriver.
Parts: Door Ajar Switch.
1. Unplug the power cord.
WARNING: Failure to do so will result in
electrical shock.
2. Remove the lower front trim by removing the 4
screws located on the sides of the trim piece.
(See Figure 7)
Figure 7
3. FOR ADJUSTMENT ONLY.
CAUTION: The following steps are performed
with the power connected to the cabinet. Use
appropriate safety.
To Increase the Switch Sensitivity:
A. Use the 1/16" (2 mm) flatblade screwdriver to
loosen the 2 screws holding the switch to the
support bracket and adjust the switch
upward approximately 1/16" (2 mm).
B. Plug the power cord back into the power
receptacle, press the ON/OFF/FAN switch to
the ON position, and open and close the
door to verify the adjustment.
23