Specifications

24
C. Repeat until the door ajar switch functions
properly.
NOTE: It is possible to adjust the door ajar switch
such that it will interfere with the reinstallation of the
lower front trim piece.
WARNING: Make sure that the door ajar switch
shield is in place prior to reinstalling the lower
front trim piece. Failure to do so may cause the
switch to malfunction.
To Decrease the Switch Sensitivity:
Figure 9
WARNING: Make sure that the door ajar switch
shield is in place prior to reinstalling the lower
front trim piece. Failure to do so may cause the
switch to malfunction.
4. FOR REPLACEMENT ONLY:
A. Use the flatblade screwdriver to loosen the 2
screws holding the switch to the support bracket.
(See Figure 8)
B. Disconnect the switch leads from the wire
harness and remove the switch from the
oven.
C. Reverse the procedure to install the new door
ajar switch.
WARNING: Make sure that the door ajar switch
shield is in place prior to reinstalling the lower
front trim piece. Failure to do so may cause the
switch to malfunction.
REPLACEMENT OF THE DOOR AJAR RELAY
(Should be done by a qualified service person)
Tools: Phillips Head Screwdriver, Needle Nose
Pliers.
Parts: Door Ajar Relay.
1. Unplug the power cord.
WARNING: Failure to do so will result in elec-
trical shock.
Figure 10
2. Using the phillips screwdriver, remove the rear
access cover. (See Figure 9)
Figure 8
3. Locate the door ajar relay on the rear com-ponent
panel and disconnect the wires from the relay with
the needle nose pliers.
4. Using the phillips screwdriver, remove the relay
from the rear component panel.
A. Use the 1/16" (2 mm) flatblade screwdriver to
loosen the 2 screws holding the switch to the
support bracket and ad-just the switch
downward approximately 1/16" (2 mm). (See
Figure 8)
B. Plug the power cord back into the power
receptacle, press the ON/OFF/FAN switch to
the ON position, and open and close the door
to verify the adjustment.
C. Repeat until the door ajar switch functions
properly.
5. Reverse the procedure and use the wiring diagram
to install the new door ajar relay.