Specifications

REPLACEMENT OF THE FAN MOTOR (Should be
done by a qualified service person)
Tools: Phillips Head Screwdriver, 5/32" (3 mm)
Hex-Key Wrench, 8" (20,3 cm) Adjustable
Wrench, Short Handle Flatblade
Screwdriver.
Parts: Fan Motor.
1. Unplug the power cord.
WARNING: Failure to do so will result in electrical
shock.
2. Remove the racks, rack supports, and interior
air baffle from the oven interior.
3. Loosen the 2 hex-key set screws on the blower
wheel and remove the wheel from the motor
shaft. (See Figure 11)
Figure 11
4. Remove the right side panel.
5. Remove the top of the motor electrical junction box
located on the top of the motor and disconnect the
wiring to the motor. (See Figure 12)
7. Remove motor ground wire.
8. Reverse the procedure and use the wiring
diagram to install the new Fan Motor.
Figure 12
REPLACEMENT OF THE OVEN CONTROLLER
(Should be done by a qualified service person)
Tools: Phillips Head Screwdriver, 11/32" (8 mm) Nut
Driver, Long nose pliers, Flatblade
screwdriver.
Parts: Oven Controller
1. Unplug the power cord.
WARNING: Failure to do so will result in electrical
shock.
25