Specifications

2, Using the phillips screwdriver, turn the 2 captive
screws at the upper and lower left-hand side of
the control panel until the panel is released.
Swing the panel open.
NOTE: The screws will remain with the panel.
3. Using the long nose pliers, disconnect the
electrical wire connections, and unscrew the
thermocouple wires. (See Figure 13)
4. Using the nut driver, remove 4 hex-nuts and
remove the oven controller. (See Figure 13)
5. Reverse the procedure to install the new oven
controller.
Figure 13
REPLACEMENT OF THE MERCURY POWER
RELAY (Should be done by a qualified service
person)
Tools: Phillips Head Screwdriver, 1/4" (6 mm)
Flatblade Screwdriver.
Parts: Mercury Power Relay.
1. Unplug the power cord.
WARNING: Failure to do so will result in
electrical shock.
2. Remove the rear access cover by removing 6
screws.
Figure 14
3. Disconnect the leads from the mercury power
relay. (See Figure 15)
4. Remove the 2 screws from the bottom left and
top right of bracket. (See Figure 15)
5. Loosen the 2 screws from the top left and
bottom right of bracket, and remove the
mercury relay by sliding it toward the top right.
(See Figure 15)
6. Reverse the procedure and use the wiring
diagram for installing the new mercury power
relay.
26