Specifications

REPLACEMENT OF THE HEATING ELEMENT(S)
(Should be done by a qualified service person)
Tools: Phillips Head Screwdriver, 3/8" (10mm) Open
End Wrench, 11/32" (8 mm) Nut-driver.
Parts: Heating Element (outer). Heating Element
(center). Heating Element (inner).
1. Unplug the power cord.
WARNING: Failure to do so will result in electrical
shock.
2. Remove the racks and rack supports. (See Figure
16)
3. Remove the interior air baffle by lifting at the
bottom and pulling forward. (See Figure 16)
Figure 16
4. Remove right side panel by removing 2 screws at
the bottom and loosening 2 screws at the top. Pull
side panel out from oven frame bottom about 1/2"
(13 mm) then pull down to remove.
NOTE:
A. Remove the outer element only when it has to
be replaced.
B. Remove the outer and center elements when
the center is to be replaced.
C. Remove all 3 elements when the inner element
is to be replaced.
5. Disconnect the wires from the element(s) that
are to be removed. (See Figure 17)
NOTE: The inner 2 connections are for the outer
heating element, the center 2 connections are for
the center heating element and the outer 2
connections are for the
inner heating element.
Figure 17
6. Remove the 6 heating element screws holding
the heating elements to the element brackets.
(See Figure 18)
7. Remove the 3 screws holding the inner portion
of the element bracket to the cavity side and
remove the 3 inner element brackets. (See
Figure 18)
27