Specifications

8. Remove the heating element(s) by pulling it
straight out from the side of the cavity.
9. Reverse the procedure and use the wiring
diagram to install the new heating elements).
REPLACEMENT OF THE POWER AND HEAT
ON LIGHTS
Tools: Phillips Head Screwdriver, Needle Nose
Pliers.
Parts: Power ON Light (red). Heat ON Light
(amber).
1. Unplug the power cord.
WARNING: Failure to do so will result in electrical
shock.
2. Using the phillips screwdriver, turn the 2 captive
screws at the upper and lower left-hand side of
the control panel until the panel is released.
Swing the panel open.
NOTE: The screws will remain with the panel.
3. Disconnect the wires from the rear of the light(s).
(See Figure 19)
4. Using the needle nose pliers, squeeze the 2 ears
on the plastic body of the light and push it out of
the control panel. (See Figure 19)
5. Reverse the procedure to install the new light(s).
REPLACEMENT OF THE LOW VOLTAGE POWER
TRANSFORMER (Should be done by a qualified
service person)
Tools: Phillips Head Screwdriver, Needle Nose
Pliers.
Parts: Transformer.
1. Unplug the power cord.
WARNING: Failure to do so will result in electrical
shock.
2. Using the phillips screwdriver, remove the rear
access cover. (See Figure 20)
Figure 20
3. Locate the low voltage power transformer on the
rear component panel and disconnect the wires
from the transformer. (See Figure 21)
4. Using the phillips screwdriver, remove the
transformer from the rear component panel.
(See Figure 21)
5. Reverse the procedure and use the wiring
diagram to install the new low voltage power
transformer.
Figure 21
Figure 19 28