Installation manual

Northern Health
Lakes District Hospital and Health Care Centre
Burns Lake, B.C
Section 11 40 03
FOODSERVICE - EQUIPMENT
ITEMIZED SPECIFCATIONS
Page 1 of 18
PART 1 ITEMIZED EQUIPMENT
NOTE: *L046 refers to the Specifier Identification System – it is not part of the model number and is
strictly for specifier identification purposes by the manufacturer.
It is the responsibility of the FEC to ensure all equipment meets or exceeds approval by authority
having jurisdiction. FEC to obtain approval where required.
It is the responsibility of the FEC to provide faucets that coordinate with the applicable sink
locations, faucet spout to extend to center of sink.
It is the responsibility of the FEC to ensure all drawers are to have drawer locks.
It is the responsibility of the FEC to ensure all equipment is provided with components to ensure it
can be installed to all applicable codes per authority having jurisdiction, including but not limited
to SMACNA guidelines
N.I.C. refers to equipment that is Not In Contract, not part of this bid package
LEED Gold project – Energy efficiency is a priority. This project is a LEED project – the FEC is to
note if equipment meets this standard or has Energy Star equivalent. All selected or proposed
alternates are to meet or exceed this standard. It is the responsibility of the successful FEC to
provide documentation to this affect.
ITEM 1
WORK TABLE 1 REQUIRED
Manufacturer: Custom Fabricated
Size: Refer to plan and elevation; 760mm deep; refer to Standard Detail D-7.1
Construction: Stainless steel construction as specified
Boxed edges
Back and end splash up 8”/200mm and splayed, closed ends
Bracing as required
Bottom shelf with boxed edges, back up 25mm and hemmed
Components: 1 required drawer, as specified, with removable plastic liner, 6”/150mm
deep
ITEM 2
OVERSHELVES 2 REQUIRED
Manufacturer: Custom Fabricated – wall mounted
Size: Refer to plan and elevation; refer to Standard Details D-4.1
Construction: Stainless steel construction as specified
Shelf with boxed edges, back up and snapped, brackets as required
Note: Coordinate with site for wall backing locations
ITEM 3
SHELVING - DRY 8 REQUIRED
Manufacturer: Metro
Model: Super Erecta Shelf *L046
Sizes: 1 required 1525 x 457mm
3 required 915 x 533mm
2 required 1220 x 533mm
2 required 1525 x 533mm
Approved
Alternate:
Nexel equivalent
Olympic equivalent
Accessories: Standard with