Installation manual

(NOT TO SCALE)
SECT. B PAGE 2
0710
Litho in U.S.A.
V
C1
D
C2
D
V
V
V
32.16”
[817mm]
30.18
[767mm]
D
D
C
C1
C2
NOTES:
Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are U.L/NSF#4 and CSA (AGA, CGA).
C
OLD WATER
C1: Feed water for reservoir, 35 Psi Minimum, 60 Psi Maximum.
C2: Drain condenser water, 35 Psi Minimum, 60 Psi Maximum.
Two 3/4" NH-F (Garden Thread) connections. Use NSF approved hose.
D
RAIN CONNECTION
1 1/4" NPT-M
Do not connect other units to this drain.
Drain line must be vented.
Do not connect the appliance’s drain connection to any drain material that
cannot sustain 140°.
VENT
V: Do not block or plug.
OPERATING CLEARANCES
3" Left, 3" Right and 4" Rear.
SERVICE CLEARANCES
12" on control side. Contact factory for variances to clearances.
CONTROLS
SureCook 60-minute electro mechanical timer with load compensating feature.
Two function control switch for Timed Cooking and Continuous Steaming.
APPROVALS
UL and
C
UL listed, classified to NSF#4 and Energy Star
H
D
C
C1 C2
H
D
C
C
1C2
• Each compartment has capacity for: Three, 12˝ x 20˝ x 21⁄2˝ deep Cafeteria Pans.
•
Each compartment has capacity for: Six, 12˝ x 20˝ x 1˝ deep Cafeteria Pans.
• Each compartment has capacity for: Two, 12˝ x 20˝ x 4˝ deep Cafeteria Pans.
H
D
C
C1 C2
ELECTRICAL
(Contact factory if installed above 3,500 feet)
WATTS VOLTS PHASE WIRES
CYCLE
AMPS
SUPPLY CONNECTION
HERTZ WIRE SIZE (COPPER)*
Standard Wattage
Three Phase - 12 kW Standard
10,725 208 3360 29.8 8
12,000 220 3360 31.5 8
14,280 240 3360 34.4 8
10,085 440 3360 13.2 12
12,000 480 3360 14.4 12
* For supply connection use only copper wire suitable for at least 75˚C. (167˚F).
WATTS VOLTS PHASE WIRES
CYCLE
AMPS
SUPPLY CONNECTION
HERTZ WIRE SIZE (COPPER)*
Standard Wattage
Single Phase - 12 kW Standard
10,725 208 1260 51.6 6
12,000 220 1260 54.5 4
14,280 240 1260 59.5 4
10,085 440 1260 22.9 10
12,000 480 1260 25.0 8