Installation manual

Northern Health
Lakes District Hospital and Health Care Centre
Burns Lake, B.C
Section 11 40 03
FOODSERVICE - EQUIPMENT
ITEMIZED SPECIFCATIONS
Page 7 of 18
Services: Refer to Services Schedule
Note: Electrical disconnect switch to be provided and installed by others (Electrical
Division) per authority having jurisdiction
ITEM 20
TRAY CART - Existing 1 EXISTING
Manufacturer: Obtain unit from owner; clean and relocate as shown
ITEM 21
MIXER STAND 1 REQUIRED
Manufacturer: Piper
Model: 121-23-29TSS - modified *L046
Approved
Alternate:
Hatch equivalent
Custom fabricated equivalent
Accessories: Standard with
Foot plates (no casters)
ITEM 22
STAINLESS STEEL SERVICE WALL 1 REQUIRED
Manufacturer: Custom Fabricated
Size: Refer to plan, elevation and section; height to underside of finished ceiling +
50mm/2” into ceiling space; refer to Standard Detail D-19.2
Construction: Stainless steel construction as specified
Floor to ceiling+, with horizontal center wall section between end chases,
partial open section from floor to approximately 24”/610mm AFF, for access
to services with full depth chases at ends, with stainless steel wall flashing
at back (wall); end chases as required for services and support – equipment
to fit tight to service wall where possible
Service chases to floor for services each end
Sides 20 gauge stainless steel spot welded to angle iron frame, with
removable panels as required for access to services
Angle iron frame to be primed with rustproof paint
Quick disconnects, electrical outlets and plumbing connection points as
noted under adjoining equipment to be fixed to angle iron frame within
service wall with drop access at horizontal section – no exposed service
lines – FEC to coordinate service runs with applicable trades
Removable panels to be removable without the use of tools where easily
accessible
All shutoff valves to be concealed in chases and easily accessible, label
valve locations
Outlets as required
Coordinate with service trades all line runs within horizontal section of
service wall between service chases to equipment and access to service
shut-off valves – no exposed/surface mounted services
Section at ends to house shut-offs etc; swing doors with full length piano
hinges; view window at fire suppression system
Services: Refer to Services Schedule
Note: Exhaust hood to be mounted on face of service wall – service wall is not to
be within exhaust hood perimeter
Coordinate with plumber for BFP locations – preference is above counter
section within wall, if BFP are not located elsewhere --- FEC to verify prior to
fabrication of service wall