Owner`s manual

pg 10 of 12
MODEL 400
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457--4926
UNITED STATES OF AMERICA E--MAIL. j
[e-mail]
FAX [phone] TEL. [phone] WWW. jarvisproducts.com
JARVIS
6205005:::.
®
MAINTENANCE INSTRUCTIONS
Always disconnect the saw from its power supply
before performing any maintenance.
Item numbers: refer to the parts diagram on page 4.
A. LUBRICATION:
1. The gear case should be kept 1/3 full of grease.
To check the grease level, remove the bottom
plate (item 41) and its gasket (item 40). It should
be checked every thirty days for saws that are
used moderately and every two weeks for saws
that are used daily. If replacement grease is re-
quired it should b e obtained from Jarvis.
B. BLADE SUPPORT INSTALLATION:
1. Tap (3) inserts (item 31) gently into the bores on
blade support clamp (item 21).
2. Align the blade support clamp onto saw housing
(item 51), making sure the inserts stay in place.
3. Assemble (3) studs (item 30) with cap nuts (item
22) and place them through the saw housing and
the blade support clamp.
4. Draw down all (3) cap nuts evenly until the in-
serts are bottomed out into the saw housing.
5. Remove the cap nuts and the blade support
clamp. The inserts should now be properly set
into the saw housing.
6. Assemble blade support (item 56) over the in-
serts on the saw housing. Place the blade sup-
port clamp on the saw housing and fasten with
the studs, the cap nuts and phillips screws (item
23).
7. Install handle stud (item 55) using two larger
phillips screws (item 53).
C. BLADE REMOVAL:
NOTE: Your Jarvis Wellsaw is equipped with a
hex key (item 20) for removing the blade. This
wrench is located in the housing directly behind
the blade support knob (item 54).
1. Insert the hex key through the hole in the outer
end of blade (item 57, 58 or 59) and pull the
blade to the outer end of the stroke.
2. Loosen the blade holding set screw (item 32)
about 1/2 turn. The set screw must be loosened
through the hole in the housing.
3. Reinsert the hex key in the hole at the outer end
of the blade and pull the blade out.
D. BLADE INSTALLATION:
1. Insert hex key (item 20) into set screw (item 32).
2. Fasten the set screw (through the hole in hous-
ing) into the hole in the end of push rod (item
19). The hole in the housing must be aligned
with the hole in the push rod for the set screw to
be fastened. (It may be necessary to turn the ar-
mature fan to adjust the push rod properly). Do
not tighten.
3. Align blade (item 57, 58 or 59) with blade sup-
port (item 56). The blade should extend approx-
imately 3 inches from the end of the blade sup-
port.
4. Slide
the blade onto the blade support until the
crimp in the blade is touching the end of the
blade support.
maintenance instructions