Installation Guide

Undermount Stainless Steel Sinks
Vitreous China Lavatories
Installation Guide
NOTE:
Due to the nature of undermount installation, Wells recommends that Wells
Sinkware undermount sinks be installed by professional installers.
The templates are only a guide. Wells strongly recommends the physical
presence of the sink when countertop is cut.
For Komponents Series multiple bowl configurations, a minimum distance of 2-
1/4'' (57 mm) is required between the bowls. Any additional required support
should be determined by the countertop supplier.
For replacement installations, make sure the existing cutout is the same size or
smaller than the cutout for the new sink.
The number of mounting clips included with your sinks may vary. Use all the
clips provided with the sink.
Allow the silicone caulk to cure following the manufacturer's instructions. All
information in this manual is based on the latest product information available at
the time of publication. Wells Sinkware Corp. reserves the right to make
revisions in the design of products without notice.
Important Information
WARNING: Risk of personal injury. Stainless Steel Sink edges are sharp and
can cause serious injuries. Use gloves and handle sink edges with caution.
1. Wells Sinkware undermount sinks can be installed in three different ways in
terms of the amount of reveal of the sink flange from the countertop cutout
opening (see Undermount Reveal Options).
WellsSinkware.com
I T ' S A W A T E R T H I N G