Specifications

TROUBLESHOOTING SUGGESTIONS
A. NO PART OF THE APPLIANCE WILL HEAT
1. Verify that appropriate cooking controls are ON.
2. Check electrical supply. Make sure service breaker is ON.
3. Possible improper service wiring: Have a licensed electrician verify that all three legs of the 3∅
service are properly connected (i.e. Leg 1 to L1, Leg 2 to L2, Leg 3 to L3), and that all three legs are
of the proper voltage and phase.
B. OVEN AND GRIDDLE WILL NOT HEAT (HOTPLATE ONLY WILL HEAT)
1. Blown fuses (item F): Correct cause of over-current and replace fuses with fuses having the same
configuration and ratings.
2. Possible internal component damage: Have unit serviced by an Authorized Wells Service Agency.
C. GRIDDLE WILL NOT HEAT
1. Verify that temperature control is set to the desired temperature.
2. Possible internal component damage: Have unit serviced by an Authorized Wells Service Agency.
D. HOTPLATE WILL NOT HEAT
1. Verify that associated temperature control is set to the desired temperature.
2. Possible internal component damage: Have unit serviced by an Authorized Wells Service Agency.
E. CONVECTION OVEN WILL NOT HEAT
1. Verify that the oven switch is ON and that the temperature control is set to the desired temperature.
2. Verify that the door is closed.
3. Hi-Limit control may have tripped: Allow unit to cool; Hi-Limit will reset automatically.
4. Blown fuse(s) (item F): Correct cause of over-current and replace fuses with fuses having the same
configuration and ratings.
5. Possible internal component damage: Have unit serviced by an Authorized Wells Service Agency.
F. CONVECTION OVEN FAN WILL NOT RUN
1. Verify that the oven switch is set to ON or FAN.
2. Verify that the fan switch is set to either HIGH or LOW.
3. Hi-Limit control may have tripped: Allow unit to cool; Hi-Limit will reset automatically.
4. Blown fuse(s) (item F): Correct cause of over-current and replace fuses with fuses having the same
configuration and ratings.
5. Possible internal component damage: Have unit serviced by an Authorized Wells Service Agency.
G. CONVECTION OVEN CONTROLLER DISPLAYS ERROR CODE
F1 Relay closed or relay ohms low when not cooking
F2 Actual temperature greater than T-SET MAX +60ºF (±35ºF)
F3 Open temperature sensor
F4 Shorted temperature sensor
F5 Relay open or relay ohms high when cooking
F6 No 60 Hz (Cycles per second other than 60 Hz detected)
CAUTION: ELECTRICAL SHOCK HAZARD
Removal of any cabinet panel will result in exposed electrical circuits.
Any procedure requiring the removal of any cabinet panel must be performed
by a qualified technician only.
Have unit serviced by an
Authorized Wells Service
Agency.
12