Specifications

PREVENTATIVE MAINTENANCE CARD
HINGE ADJUSTMENT
COMBINATION COOK CENTER OC-2HG
272.4
page 1 of 2
PRECAUTIONS: None
FREQUENCY: As Required
TOOLS: Phillips (+) Screwdriver, 4"x2" Strip of 20# Paper
7/16" Nut Driver, 7/8" and 1-1/8" Wrenches
CAUTION: Exposed Electrical Circuits
Use care to avoid wiring for hotplate section during this procedure
1. The hinges provide the pivot for the door, allow for height adjustment and alignment so that
the door closes properly on the gasket.
2. To access the hinge adjustments:
a. Remove the grease tray. Remove the upper trim panel by removing the four screws at
the ends of the panel. The trim panel / grease tray support assembly will then pull
straight out.
b. Remove the bottom trim panel by removing the four screws at the ends of the panel, and
by loosening the two screws holding the bottom door gasket. The panel will then pull
straight out.
TO BE PERFORMED BY QUALIFIED PERSONEL ONLY
TOP
PANEL
BOTTOM
PANEL
CHECK ALIGNMENT
APPROXIMATELY
EQUAL
CLEARANCES
21
DO NOT REMOVE FROM MANUAL - PHOTOCOPY FOR DISTRIBUTION
04/04/00