405 WELLS BLOOMFIELD, LLC 10 Sunnen Dr., St. Louis, MO 63143 telephone: 314-678-6314 fax: 314-781-2714 www.wellsbloomfield.com OPERATIONS MANUAL DROP-IN REFRIGERATED COLD PANS, NSF7 RCP-7100, RCP-7200, RCP-7300, RCP-7400, RCP-7500, RCP-7600. DROP-IN REFRIGERATED COLD PANS, NSF2 RCP-100, RCP-200, RCP-300, RCP-400, RCP-500, RCP-600. DROP-IN REFRIGERATED COLD PANS, SLOPE TOP NSF7 RCP-7100ST, RCP-7200ST, RCP-7300ST, RCP-7400ST, RCP-7500ST, RCP-7600ST.
LIMITED WARRANTY STATEMENT Unless otherwise specified, all commercial cooking equipment manufactured by WELLS BLOOMFIELD, LLC is warranted against defects in materials and workmanship for a period of one year from the date of original installation or 18 months from the date of shipment from our factory, whichever comes first, and is for the benefit of the original purchaser only.
TABLE OF CONTENTS WARRANTY INTRODUCTION & SPECIFICATIONS FEATURES & OPERATING CONTROLS PRECAUTIONS & GENERAL INFORMATION AGENCY LISTING INFORMATION INSTALLATION OPERATION CLEANING INSTRUCTIONS MAINTENANCE INSTRUCTIONS OPERATING INSTRUCTIONS TROUBLESHOOTING SUGGESTIONS WIRING AND REFR. DIAGRAMS BLANK PAGE FOR NOTES ACCESSORY PARTS & SERVICE DATA xi 1 2 3 4 5, 6, 7 8 9 10, 11 12, 13 14 15 16 17 INTRODUCTION Thank you for purchasing this Wells Bloomfield appliance.
FEATURES & OPERATING CONTROLS 2 M405 p/n 2M-305101 Owmers Manual Drop-In Refrigerated Cold Pans NOTE: This is a general arrangement drawing only. Actual component positions may vary between units.
PRECAUTIONS AND GENERAL INFORMATION This appliance is intended for use in commercial establishments only, and is intended to hold pre-chilled prepared food for human consumption. No other use is recommended or authorized by the manufacturer or its agents. Operators of this appliance must be familiar with the appliance use, limitations and associated restrictions. Operating instructions must be read and understood by all persons using or installing this appliance. Food must be kept in appropriate inserts.
AGENCY LISTING INFORMATION STD 2 STD 7 This appliance performance tested to NSF Standard 7 for storage of potentially hazardous foods. This appliance meets NSF Standard 7 only when pan rails are installed in the lowest position, otherwise it meets NSF Standard 2. RCP units are ETL listed for US and Canada RCP units are evaluated to UL standard 471. UL471 Components used in the manufacture of this unit are Underwriters Laboratory recognized.
INSTALLATION UNPACKING & INSPECTION Carefully remove the appliance from the carton. Remove all protective plastic film, packing materials and accessories from the Appliance before connecting electrical power or otherwise performing any installation procedure. Carefully read all instructions in this manual and the Installation Instruction Sheet packed with the appliance before starting any installation. Read and understand all labels and diagrams attached to the appliance.
INSTALLATION WARNING: ELECTRIC SHOCK HAZARD All servicing requiring access to non-insulated electrical components must be performed by a factory authorized technician. DO NOT open any access panel which requires the use of tools. Failure to follow this warning can result in severe electrical shock. CAUTION: ELECTRICAL INSTALLATION 1. Refer to the nameplate. Verify the electrical service power. Voltage and phase must match the nameplate specifications.
INSTALLATION PLUMBING INSTALLATION Install 1" drain valve (provided by others) on unit drain. Plumb to an appropriate waste as required by local plumbing and sanitation ordinances. Consult local codes for approved drain configurations. IMPORTANT: DO NOT allow the sink drain spud to turn during installation.
OPERATION CAUTION: ELECTRIC SHOCK HAZARD DO NOT splash or pour water onto control panel or wiring. RCP units are designed to hold REFRIGERATED PRE-CHILLED product at serving temperature. RCP units should not be used to chill product, nor to hold product for long term storage. OPERATION NOTES 1. Never place food directly in cold tank. Always use insets or food pans. 2. Use only pre-chilled products. Stir product occasionally to maintain an even temperature. 3.
CLEANING INSTRUCTIONS PREPARATIONS: Turn POWER SWITCH OFF. Unplug unit or disconnect from electric power. Allow unit to defrost before proceeding. Remove any insets, pans and/or adapter tops ( if used). Drain water from tank. FREQUENCY: Daily TOOLS: Warm Water and Mild Detergent Solution: 10 Parts Warm Water to 4 Parts Vinegar Plastic Scouring Pad Clean Cloth or Sponge Food-Grade Silicone Sealant 1. Remove pan adapter bars, pan rail and drain screen.
MAINTENANCE INSTRUCTIONS CAUTION: PERSONAL INJURY HAZARD Disconnect appliance from electrical power before cleaning condenser coil. CAUTION: PERSONAL INJURY HAZARD Condenser coil fins are sharp. Use care to avoid cuts while cleaning the condenser. CONDENSER COIL CLEANING INSTRUCTIONS The condenser coil must be kept clean to allow adequate air flow for proper heat dissipation. Recommend this procedure be performed monthly. 1. Turn POWER SWITCH OFF. Disconnect unit from electrical power. 2.
MAINTENANCE INSTRUCTIONS CAUTION: PERSONAL INJURY HAZARD Disconnect appliance from electrical power before cleaning. Wells refrigerated cold pans are constructed of high quality stainless steel. As long as the stainless steel surface is intact, the equipment will not rust or corrode. M405 p/n 2M-305101 Owmers Manual Drop-In Refrigerated Cold Pans Recommendation: A water softening device or a cartridge-type filtration device may be used to minimize lime and calcium build-up.
OPERATING INSTRUCTIONS IMPORTANT: DO NOT adjust the differential settings of the refrigeration system. Field adjustments of the differential settings must be made by qualified refrigeration personnel only. Unauthorized adjustment of the differential settings will void the warranty. TEMPERATURE ADJUSTMENT RCP-100(ST) thru RCP-600(ST) 1. The temperature has been preset at the factory to meet most applications. 2.
OPERATING INSTRUCTIONS 3. Press the SET key again to access the differential. The LCD will display the current differential, and the DIF1 annunciator will blink off and on to indicate that control is in the differential mode. IMPORTANT: DO NOT adjust the differential settings of the refrigeration system. Field adjustments of the differential settings must be made by qualified refrigeration personnel only. Unauthorized adjustment of the differential settings will void the warranty.
TROUBLESHOOTING M405 p/n 2M-305101 Owmers Manual Drop-In Refrigerated Cold Pans 14
WIRING AND REFRIGERATION SCHEMATICS MODELS RCP-100-600 MODELS RCP-300 THRU 600 WIRING SCHEMATIC COMPRESSOR MOTOR COMPRESSOR WIRING COMPARTMENT START AND RUN WINDINGS WIRING COMPARTMENT HIGH PRESSURE CUTOUT FOR RCP-500 AND -600 1 C CONDENSER FAN MOTOR OVERLOAD BLACK BLACK 2 GREEN 1 GREEN R S M 1 2 3 RELAY GREEN 4 WHITE S BLACK BLACK NEMA 5-15P CORDSET ON/OFF SWITCH ADJUSTABLE PRESSURE CONTROL (MODELS RCP 100-600) START CAPACITOR FAN MOTOR WHITE BLACK ADJUSTABLE PRESSURE CONTRO
NOTES: M405 p/n 2M-305101 Owmers Manual Drop-In Refrigerated Cold Pans 16
ACCESSORY PARTS & SERVICE DESCRIPTION PART NO.
WELLS BLOOMFIELD, LLC 10 Sunnen Dr., St. Louis, MO 63143 telephone: 314-678-6314 fax: 314-781-2714 www.wellsbloomfield.
