Specifications

ManualsBrandsWells ManualsKitchen AppliancesRW-36HD

PRINTED IN UNITED STATES OF AMERICA

WELLS BLOOMFIELD, LLC

2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439

www.wellsbloomfield.com

telephone: 775-689-5703

fax: 775-689-5976

IMPORTANT: DO NOT DISCARD THIS MANUAL

This manual is considered to be part of the appliance and is to be given to the OWNER or

MANAGER of the restaurant, or to the person responsible for TRAINING OPERATORS of

this appliance. Additional manuals are available from your WELLS DEALER.

THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR

INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any

questions concerning installation, operation or maintenance of this equipment.

OPERATION MANUAL

BUILT-IN DRAWER WARMERS

MODELS

RW-16 thru RW-36 Standard

RW-16HD thru RW-36HD and RW-176HD

RWN-16 thru RWN-36 Narrow

Includes

INSTALLATION and USE & CARE

042

p/n 303334 Rev. C ECN-13371 M042 071025 cps

Model RWN-2

Model RW-26HD

Summary of content (14 pages)

PAGE 1
042 WELLS BLOOMFIELD, LLC 2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439 telephone: 775-689-5703 fax: 775-689-5976 www.wellsbloomfield.
PAGE 2
LIMITED WARRANTY STATEMENT Unless otherwise specified, all commercial cooking equipment manufactured by WELLS BLOOMFIELD, LLC is warranted against defects in materials and workmanship for a period of one year from the date of original installation or 18 months from the date of shipment from our factory, whichever comes first, and is for the benefit of the original purchaser only.
PAGE 3
TABLE OF CONTENTS WARRANTY SPECIFICATIONS FEATURES & OPERATING CONTROLS PRECAUTIONS & GENERAL INFORMATION AGENCY LISTING INFORMATION INSTALLATION OPERATION CLEANING INSTRUCTIONS TROUBLESHOOTING SUGGESTIONS MAINTENANCE INSTRUCTIONS PARTS & SERVICE CUSTOMER SERVICE DATA xi 1 2 3 3 4 6 8 9 10 11 11 INTRODUCTION Thank You for purchasing this Wells Bloomfield appliance.
PAGE 4
FEATURES & OPERATING CONTROLS (continued) 042 p/n 303334 OpM BI Drawer Warmer 2
PAGE 5
PRECAUTIONS AND GENERAL INFORMATION This appliance is intended for use in commercial establishments only. This appliance is intended to prepare food for human consumption. No other use is recommended or authorized by the manufacturer or its agents. Operators of this appliance must be familiar with the appliance use, limitations and associated restrictions. Operating instructions must be read and understood by all persons using or installing this appliance.
PAGE 6
INSTALLATION NOTE: DO NOT discard the carton or other packing materials until you have inspected the appliance for hidden damage and tested it for proper operation. Refer to SHIPPING DAMAGE CLAIM PROCEDURE on the inside front cover of this manual. WARNING: PERSONAL INJURY RISK Installation procedures must be performed by a qualified technician with full knowledge of all applicable electrical and plumbing codes. Failure can result in personal injury and property damage.
PAGE 7
INSTALLATION (continued) 7. Reinstall drawer(s) in unit: a. Check the roller catch inside the cabinet. The spring-loaded roller arm must be extended. b. With the front of the drawer assembly tipped downward, engage the roller on the drawer with the cabinet drawer slide. c. Raise the drawer to the horizontal position until the drawermounted slide engages the dual roller assembly on the cabinet. d. Slide the drawer in until the catch engages. The drawer should remain tightly closed. e. Slide the drawer out.
PAGE 8
OPERATION CAUTION: HEATING OPTIONS HOT SURFACE 1. Moist heat with Humitrol Rack: a. MOIST operation prevents food from drying out as heat is applied to the warming chamber. b. To set for MOIST operation, remove the Humitrol Rack from bottom of drawer insert pan and carefully pour approximately 2 quarts of water (½” depth) into the pan. Reinstall rack. c. When the drawer is closed, the Humitrol Rack allows water vapor to rise through the stored product in the drawer.
PAGE 9
OPERATION (continued) OPERATION CAUTION: 1. Determine the type of food to be warmed. Hot Surface 2. Refer to the chart on page 6 to determine the type of heat required. 3. Set the air vent control for the type of heat, and rotate the thermostat knob to the temperature setting desired. Exposed surfaces can be hot to the touch and may cause burns. 4. Allow warmer to pre-heat for approximately 30 minutes before use. CAUTION: DO’S and DON’TS 1. DO DO NOT Always use a drawer pan.
PAGE 10
CLEANING INSTRUCTIONS CAUTION: PRECAUTIONS: Turn control knob to OFF. Allow drawers to cool before proceeding. Remove drawer pans and Humitrol racks. FREQUENCY: Minimum -Daily TOOLS: Warm water and mild detergent Clean cloth or sponge ELECTRIC SHOCK HAZARD Disconnect appliance from electric power before cleaning. CAUTION: HOT SURFACE Exposed surfaces can be hot to the touch and may cause burns. Allow appliance to cool before cleaning. 1. Remove drawers from warmer: a.
PAGE 11
TROUBLESHOOTING SUGGESTIONS SYMPTOM No lights or heat (all drawers) No heat (one drawer) Food dries out Food gets soggy Drawer falls open 042 p/n 303334 OpM BI Drawer Warmer Drawer falls out when opened POSSIBLE CAUSE SUGGESTED REMEDY Warmer unplugged Plug warmer into appropriate receptacle Circuit breaker off or tripped Reset circuit breaker Internal damage Contact an Authorized Wells Service Agency for repairs. Temperature control not set Set for desired temperature.
PAGE 12
MAINTENANCE INSTRUCTIONS (continued) CAUTION: ADJUSTMENTS AND LUBRICATION ELECTRIC SHOCK HAZARD PRECAUTIONS: Turn control knob to OFF. Unplug warmer Allow drawers to cool before proceeding. Remove drawer pans and Humitrol racks FREQUENCY: Minimum - monthly. Every 2 weeks recommended. TOOLS: Screwdrivers, Phillips (+) and flat blade (-). Nut drivers, 3/8” and 7/16”. Food-grade lubricant. Disconnect appliance from electric power before cleaning.
PAGE 13
PARTS & SERVICE DESCRIPTION PART NO. HUMITROL RACK PAN, STAINLESS (ALL EXCEPT RWN) PAN, STAINLESS (RWN ONLY) 20624 21488 22228 IMPORTANT: Use only factory authorized service parts and replacement filters. For factory authorized service, or to order factory authorized replacement parts, contact your Wells authorized service agency, or call: Wells Bloomfield, LLC 2 Erik Circle P. O. Box 280 Verdi, NV 89439 Service Parts Dept.
PAGE 14
Commercial Food Equipment Service Association Wells Bloomfield proudly supports CFESA Commercial Food Equipment Service Association SERVICE TRAINING - QUALITY SERVICE Genuine Parts Protect - YOU - All - Ways CUSTOMER SATISFACTION WELLS BLOOMFIELD, LLC 2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439 telephone: 775-689-5703 fax: 775-689-5976 www.wellsbloomfield.