Installation Instructions

Art Glass Vessels

Wells Sinkware art glass vessels have 8 size-shape combinations (styles) (See

Art Glass Vessel Style Chart ). Some vessels (double layered in Style C and D)

are intended for both above-counter and partial recess installations, while all

the others should be only installed above the counter.

For above-counter installation

Step 1: In the countertop*, drill a hole 1 3 /4 diameter where

the vessel bowl will be centered.

Step 3: Use a generous portion of plumbers' putty under

the drain cup of the lavatory drain supplied with the vessel

and insert the whole body of the drain inside the bowl and

through the countertop.

There may be a small beveled rubber washer included with

your drain, discard it and use plumbers' putty instead.

Step 4: From under the drain, insert the thick rubber washer

and tighten it by hand**. Remove excess plumbers' putty.

, screw on the metal nut

Group 1 Group 2

Mounting Ring Details

Drain Assembly Details

Horizontal View Vertical View

Installation Guide

Step 2: Place mounting ring under the vessel as shown below if the vessel has a

rounded bottom (Style A, C, D and G: Group 1), or directly put the vessel on top of the

hole drilled in the countertop if the vessel has a flat bottom (Style B, E, H and I: Group

2).

Drain Cup

Thick Rubber Washer

Metal Nut

Tailpiece

Rubber Washer

Mounting Ring

Bottom O-ring

WellsSinkware.com

I T ' S A W A T E R T H I N G

PAGE 1
WellsSinkware.com I T ' S A W A T E R T H I N G Installation Guide Art Glass Vessels Wells Sinkware art glass vessels have 8 size-shape combinations (styles) (See Art Glass Vessel Style Chart ). Some vessels (double layered in Style C and D) are intended for both above-counter and partial recess installations, while all the others should be only installed above the counter. For above-counter installation Step 1: In the countertop*, drill a hole 1 3/4'' diameter where the vessel bowl will be centered.
PAGE 2
WellsSinkware.com I T ' S A W A T E R T H I N G For partial recess installation Step 1: Cut a hole of certain diameter with a beveled edge with certain angle (this has to be determined by your professional countertop fabricator) that allows your vessel recessed into the hole to certain depth of your preference. Step 2: Apply a bead of silicone caulk along the edge of the hole and press the vessel against the edge and adjust it to the right position.