Operating instructions

LIFT MOTOR
ASSEMBLY INSTRUCTIONS
11
10-32 truss head:
nut inside /
head outside
B
Lube lift cradle side of
brace w/ Teflon hi-temp
grease (Accrolube)
Adjust this clearance to .05”,
or about the thickness of
a matchbook cover
C
Lube channel of cradle lift
w/ Teflon hi-temp grease
Assemble roller to
actuator with lock washer
and Red Loctite
Roller should ride
smoothly in channel
Adjust microswitch such
that the cam
actuates the switch
during its entire travel
positively
Be sure to install the
insulator between the
microswitch and the
motor mount
D
E
Assemble with white
Teflon washer between
actuator and motor
Assemble with cam toward
motor
Use Purple Threadlock
on actuator set screws
MOTOR
SHAFT
CAM
A
B
C
D
E
LONG END OF ROD
LONG ARM
OF ACTUATOR
Drill mounting holes in motor case to 13/64“
Use 10-32 ss countersunk screws with
Tenz nuts on motor side
A
Lube rod & bushing
w/vegetable oil
Clamp secures bushing
8-32 truss head:
head inside / nut outside
Rod assembles through
bushing in lip of frypot
Make sure bushing is
present. Lube w/
vegetable oil
Secure wiring with tie wrap
to prevent interference
with actuator
Frypot bushing
Frypot
Assemble conduit connector to
motor mount w/ fiber washer and
Purple Threadlock