Operating instructions

TROUBLESHOOTING
20
SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY
Fryer will not heat
Unit disconnected from electric power Reconnect to power
Check/reset circuit breaker
Temp control thermostat (item 10) not set Set thermostat to desired temperature
Hi-Limit thermostat (item 9) tripped Allow unit to cool, reset hi-limit
See page 3
Internal damage Contact your Authorized Wells Service
Agency for repairs
Lift cradle will not lower
Timer not set or not activated Set timer to other than “0”, press red
button to lower cradle.
Internal damage or mis-adjustment Contact your Authorized Wells Service
Agency for repairs
Lift cradle not properly assembled to lift
rod
Properly assemble cradle pivot to lift rod
Internal damage or mis-adjustment Contact your Authorized Wells Service
Agency for repairs
Filter pump will not run
or pump overload trips frequently
Switches not set for filtering Press power switch (item 1) to FILTER
Press pump filter switch (item 6) to ON
Pump overload (item 9) tripped Reset overload. Press red button until it
“clicks” and stays locked in
(Fryer with optional wand only) 3-way
valve not in “frypot” position
Be sure valve is in “frypot” position, or that
valve is in “wand” position with wand fully
seated in quick disconnect fitting.
Filter reservoir overflows
during filter cycle
Drain valve (item 11) not properly set Oil level in reservoir must be manually
monitored at all times while filtering.
Adjust flow by opening or closing drain
valve
Filter paper surface clogged with crumbs
or other cooking debris
Turn drain valve OFF. When bubbles
begin appearing in frypot turn filter pump
switch OFF. Carefully slide reservoir out
6” and clear surface of filter paper with
hi-temp brush or wooden dowel. Reinstall
reservoir and resume filtering.
Filter pump won’t pump, or pumps air
when filtering
Suction tube not seated, allowing air to
enter system
When inserting filter reservoir be sure
suction tube is fully seated in suction line
receptacle.
Suction tube o-ring damaged Replace o-ring
Internal damage Contact your Authorized Wells Service
Agency for repairs
NOTE: There are no user serviceable
components in the fryer. In all cases of
damage or malfunction, contact your
Authorized Wells Service Agency for
repairs.
Lift cradle will not raise
Fryer safety switch not made
(fryer with optional wand only)
Be sure drain lever is horizontal
Internal damage (pump overload trips
frequently)
Contact your Authorized Wells Service
Agency for repairs
361 301669 OpManual for WFAE-30F Electric Fryer