Product manual

Wells WFPE-68KFC Pressure Fryer
Wells WFPE-68KFC Pressure Fryer 01/26/04 Page 7
10
Refrigerate
collector
gasket in
water
• Remove o-ring from collector and clean with cold, damp
towel. Place o-ring in fresh water in refrigerator.
• Clean collector at sink with HOT water ONLY.
11
Clean
frypot
• Place large stockpot under frypot
• Scrape crackling ring from frypot and discard.
• Rinse frypot with hot water.
• Scrub frypot behind heating element coils and
heater brackets with the teflon brush and hot
water, then rinse.
• Wipe frypot with damp towel, then with dry
towel.
• Remove stockpot.
12
Dry coils
and
brackets
• Wrap dry towel around bristle end of brush and dry heating
element coils and brackets.
13
Replace
lid and
collector
o-rings
• Remove spare lid and collector o-rings from refrigerator.
• Dry o-rings thoroughly, then lubricate with liquid shortening.
• Install lid o-ring on lid and collector o-ring on collector.
(The collector o-ring must be in place to prevent shortening
from leaking.)
14
Install
collector
• Install collector in frypot. Press to seat against bottom of fryer.
• Leave heat plate on top of fryer overnight.
15
Remove
and clean
condensate
tray
• Slide condensate tray out of fryer. Use both handles to carry.
• Pour contents into a container to let shortening solidify. Skim
off shortening and discard. Pour ONLY WATER down floor
drain.
• Clean condensate tray. Spray at sink with hot water ONLY.
• Dry condensate tray with a towel, then reinstall in fryer.