Specifications

DAILY START-UP
Remove the DEAD WEIGHT COVER.
Verify that the DEAD WEIGHT is in place
and that the vent holes are clean and free
from obstructions. Be sure the gasket is in
position, then latch the cover in place.
Be sure the EXHAUST VENT is free from
obstructions.
Open the FRYPOT LID. Turn the operating lever fully clockwise.
Slide pivot tube forward until it drops into the indents in the rods.
Slide the lid and yoke assembly to the rear until the lid pivot is in
the pivot tube.
Using the LID HANDLE, lift the front of the lid and yoke until it
rests on the REAR SUPPORT in the raised position.
Lubricate a freshly cleaned LID O-RING with a thin coating of
vegetable oil, then install the o-ring in the groove in the lid. Set the
lid and yoke assembly back onto the glides.
Lift the pivot tube slightly and slide it to the rear of the fryer.
Be sure the frypot is clean, and all breading and crumbs have been
brushed from between the heating elements.
Lubricate a freshly cleaned COLLECTOR O-RING with a thin
coating of vegetable oil, then install the o-ring in the groove in the
COLLECTOR*. Fully insert the COLLECTOR ASSEMBLY into the
opening in the bottom of the FRYPOT. DO NOT install the HEAT
TRANSFER PLATE at this time.
Check the DRAIN VALVE.
Make sure the valve is fully
closed.
Be sure the CONDENSATE TRAY
is empty and properly installed.
OPERATION
8
USE AND CARE
DANGER:
BURN
HAZARD
Contact with hot shortening
will cause severe injury or
death. Wear protective
gloves and clothing when
operating this fryer.
CAUTION
SHOCK HAZARD
If you experience an electrical
shock from the fryer:
IMMEDIATELY disconnect
the fryer at the circuit breaker
and contact an
AUTHORIZED WELLS
SERVICE AGENT for repairs.
GENERAL GUIDELINES
ALWAYS be sure the
pressure gauge reads "0"
before turning the operating
lever clockwise.
ALWAYS be sure the
LID O-RING is in good
condition and properly
installed.
*IMPORTANT:
Collector MUST be Wells-
type collector with collapsible
handle welded to the bottom.
ALWAYS be sure the
COLLECTOR O-RING is in
good condition and properly
installed.