Specifications

23
CABINET COMPONENTS
A. Removable Components
The following major components may be removed without the use
of service tools:
Lid and Yoke Assembly
Condensate Tray
Collector and Heat Transfer Plate (use the Collector Lifting Tool)
Dead Weight Cover and Dead Weight
Remove the Muffler by loosening the four hose clamps that secure
the exhaust tubing. Work the tubing off of the vent tubes, then lift
the muffler out of the cabinet.
B. Access Panels
Remove the following panels by removing two screws at the
bottom, then sliding the panel out of the channel in the frame:
Lower Front Panel
Right Side and Left Side Panels
Upper Rear Panel
After removing the Lower Front Panel, remove two screws at the
bottom of the Upper Front Panel and slide it out of the frame.
Disconnect the controller connectors in the front electrical
compartment.
The Electrical Shelf is held by two screws at the bottom, and slides
out to the limit of the wiring.
SERVICE
These servicing instructions are intended for use by qualified technical personnel only.
WARNING
Electric Shock
Hazard
Disconnect from electrical
power before removing any
panel or cover.
CAUTION
BURN
HAZARD
Allow fryer to cool. Be sure
all pressure is relieved before
proceeding.
TOOLS REQUIRED:
#2 Phillips Screwdriver
Container to hold
fasteners
IMPORTANT:
Yoke and lid assembly
weighs approximately 70 lbs.
Use appropriate lifting
procedures.
SERVICING INSTRUCTIONS