Specifications

A. Access
Turn operating lever fully clockwise. Slide yoke and lid assembly to
the rear until it clears the blocks. Assembly may be lifted off, or
work may be performed in place.
IMPORTANT: Yoke and lid assembly weighs approximately 70 lbs.
Use appropriate lifting procedures.
B. Yoke Assembly
Remove two screws from CAP.
Remove three inside screws/lock washers holding CAM PLATE.
Lift YOKE ASSEMBLY off of LID AND PISTON ASSEMBLY.
Glides: Remove two screws holding glides to yoke.
No other field operations can be performed on the yoke assembly.
C. Lid and Piston Assembly
O-RING may be worked out of the groove in the lid. Lubricate
o-ring with clean vegetable oil before reinstalling.
Remove four screws/lock washers holding piston to lid.
Reassemble in reverse order
Remove four screws holding LID REAR SUPPORT/PIVOT to lid.
Unscrew PRESSURE RELIEF TUBE from PRESSURE RELIEF
VALVE. Unscrew PRESSURE RELIEF and PRESSURE GAUGE
from lid. Unscrew ADAPTER from PRESSURE RELIEF VALVE.
To reinstall, lightly coat male threads with hi-temperature silicone
sealant.
Reassemble in reverse order.
Lubricate cam with food-grade grease before installing cam plate
and cap.
When reassembling lid & piston to yoke, support lid and piston on
a suitable 1" high object to ease installation of cam plate.
Be sure lid is assembled to yoke with the pressure gauge on the
operating lever side.
CAUTION
BURN
HAZARD
Allow fryer to cool. Be sure all
pressure is relieved before
proceeding.
TOOLS REQUIRED:
#2 & #3 Phillips Screwdrivers
Flat Blade Screwdriver
Screw Starter
7/16" Box End Wrench or
Hex Socket
1/2" & 1" Open End
Wrenches
Container to hold
Fasteners
IMPORTANT:
Yoke and lid assembly
weighs approximately 70 lbs.
Use appropriate lifting
procedures.
ASSEMBLY & TORQUE
SPECS:
Piston Assy to Lid
Loctite™246
Lockwasher (35486)
75 in.-lbs
Cam Plate to Piston Assy
Loctite™246
Lockwasher (35486)
75 in.-lbs
SERVICING INSTRUCTIONS (continued)
SERVICE
26
These servicing instructions are intended for use by qualified technical personnel only.
YOKE AND LID ASSEMBLY