Specifications

SERVICING INSTRUCTIONS (continued)
SERVICE
27
These servicing instructions are intended for use by qualified technical personnel only.
MOUNTING BLOCKS AND ASSOCIATED COMPONENTS
A. Access
Turn operating lever fully clockwise and slide lid and yoke assembly
to rear until it clears the blocks. Lift lid and yoke off of fryer.
IMPORTANT: Yoke and lid assembly weighs approximately 70 lbs.
Use appropriate lifting procedures.
Remove LEFT SIDE PANEL, RIGHT SIDE PANEL and UPPER
REAR PANEL.
B. Pivot Tube and Guide Rods
Loosen screws in top of ROD MOUNTING BLOCKS. Slide GUIDE
RODS to the rear. Slide PIVOT ROD forward until it clears the
GUIDE RODS.
To reinstall, be sure guide rods are properly oriented with the flat
ends toward the rear and the locating notch “up”. Pivot tube must
be positioned on the guide rods with the ears “up” and the handle
on the right side. After installation, test pivot rod for smooth
operation, to be sure it locates securely into the notches, and that it
is easily moved from the notches.
C. Mounting Blocks
Remove five bolts from each mounting block. Note that mounting
blocks may be attached with sealant to cabinet top.
To reinstall, be sure mounting blocks are oriented with the smooth
side toward the outside, and the notched upper flange toward the
rear. Apply a thin bead of food-grade silicone sealant to the bottom
of the mounting block before installing.
D. Basket Hook Support Block
Remove two bolts from support block. Note that support block may
be attached with sealant to cabinet top.
To reinstall, be sure support block is oriented with the smooth
side toward the frypot. Apply a thin bead of food-grade silicone
sealant to the bottom of the block before installing.
CAUTION
BURN
HAZARD
Allow fryer to cool. Be sure all
pressure is relieved before
proceeding.
TOOLS REQUIRED:
3/8" & 3/4" Sockets w/ 4"
extension
Container to hold
fasteners
Food-Grade Silicone Sealant
IMPORTANT:
Yoke and lid assembly
weighs approximately 70 lbs.
Use appropriate lifting
procedures.
ASSEMBLY & TORQUE
SPECS:
Mounting Blocks
Loctite™246
80 ft.-lbs
Basket Hook Block
Loctite™246
Lockwasher (37500)
20 ft.-lbs