Specifications

SERVICING INSTRUCTIONS (continued)
SERVICE
31
SOLENOID AND RELATED COMPONENTS
A. Access
Remove RIGHT SIDE PANEL and UPPER REAR PANEL.
B. Pivot Arm
Remove cotter pin from lower portion of CONNECTING ROD.
While supporting the assembly, remove four nuts holding PIVOT
ARM and BRACKET to cabinet. Lower carefully. Be sure to
withdraw RELIEF PIN from pressure relief body and store safely.
Remove RETAINING PIN. Withdraw PIVOT. Be sure to capture
PIVOT BUSHING.
C. Solenoid
Remove three screws holding MOUNTING BRACKET COVER to
mounting bracket. Remove cover.
Disconnect wiring from SOLENOID.
Remove cotter pin from upper portion of CONNECTING ROD.
Remove four nuts holding solenoid to mounting bracket. Remove
solenoid from bracket.
Disassemble STRAIN RELIEF from mounting bracket only if
replacing wiring.
Reassemble in reverse order. Replace cotter pins if worn or damaged.
WARNING
Electric Shock
Hazard
Disconnect from electrical
power before removing any
panel or cover.
TOOLS REQUIRED:
#2 Phillips Screwdriver
Needle Nose Pliers
Container to hold
fasteners
These servicing instructions are intended for use by qualified technical personnel only.
These servicing instructions are intended for use by qualified technical personnel only.