Specifications

UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all protective
plastic film, packing materials and accessories from the appliance
before connecting electrical power or otherwise performing any
installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the appliance before starting any
installation.
Read all instructions in this manual carefully before starting installation
of this fryer. READ AND UNDERSTAND ALL LABELS AND
DIAGRAMS ATTACHED TO THE FRYER.
Carefully account for all components and accessories before
discarding packing materials.
1 ea Fryer Basket
1 ea Condensate Tray
1 ea Basket Drain Hook/Collector Lifting Tool
1 ea Frypot Stirring Tool
1 ea Collector
1 ea Displacement Tool
1 ea Cleaning Brush
2 ea Lid O-Ring
2 ea Collector O-Ring
1 ea Heat Transfer Plate
Store these components in a convenient place for later use:
SETUP
Verify that this fryer installation is in compliance with the specifications
listed in this manual and with local code requirements. THIS IS THE
RESPONSIBILITY OF THE INSTALLER.
Setup the fryer only on a firm, level, non-combustible surface. Verify
local codes for requirements. Concrete, tile, terrazzo or metal surfaces
are recommended. Metal over combustible material may not meet
code for non-combustible surfaces.
Verify that the unit sits firmly ON BOTH LEGS AND BOTH WHEELS.
With a spirit level, check that the appliance is level front-to-back and
side-to-side. With the adjustable legs, adjust as required to level the
appliance. Both legs must be adjusted to firmly contact the floor in
order to prevent tipping.
Some locations require the fryer to be secured to prevent tipping or
rolling. It is the responsibility of the installer to meet this requirement.
DO NOT store flammable or combustible items (mops, paper, rags or
chemicals) in, on or near the fryer.
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
WARNING:
Risk of
personal injury
Installation procedures must
be performed by a qualified
technician with full knowledge
of all applicable electrical
codes. Failure can result in
personal injury and property
damage.
INSTALLATION
INSTALLATION
6