Service manual

DELIMING INSTRUCTIONS (continued)
4. Squeeze solution bottle and force deliming solution into Water-
Max™
5. Press latch on tank quick-disconnect fitting until it “clicks” to release
the solution bottle. Lift solution bottle straight up.
Unscrew quick-disconnect cap allowing solution bottle to return to
shape.
Rinse solution bottle with warm tap water. Fill solution bottle
2/3 full of warm tap water and reattach quick-disconnect cap.
After 10 minutes, insert solution bottle in quick-disconnect fitting.
Push down on bottle until latch “clicks”. Squeeze bottle, rinsing
quick-disconnect fittings and forcing deliming solution in Water-
Max™ into the tank.
Press latch on tank quick-disconnect fitting to release the solution
bottle. While pressing button, lift solution bottle straight up. Press
the valve on the solution bottle fitting to allow the bottle to return to
shape. Press the small plunger on the Water-Max™ quick-
disconnect to release the latch. Wipe both quick-disconnect fittings
with a soft cloth.
The quick disconnect fittings are now ready for the next deliming
session.
6. Press power switch to ON. Water-Max™ will dispense water and
any remaining deliming solution into tank.
When Water-Max™ stops dispensing, press power switch to OFF.
Allow Water-Max™ to set for I HOUR with deliming solution in
tank.
After I hour, drain pitchers of water from tank until tank is
empty.
Pour all water and solution from tank into a sink or appropriate
container for disposal.
REMOVE
BOTTLE
REMOVE
BOTTLE
WIPE
QUICK-
DISCONNECTS
RINSE
BOTTLE
THEN
FILL WITH
TAP WATER
INSERT &
SQUEEZE
10 MIN
WAIT
SQUEEZ
E
UNTIL
TANK
IS
EMPTY
ON
1 HOUR
OFF
WAIT
7