Operating instructions

MAINTENANCE - FILTER OPERATION
12
FILTER PAPER INSTALLATION
1. Open FRYER DOOR and remove FILTER RESERVOIR.
2. Remove FILTER PAPER HOLDER, used FILTER PAPER and
FILTER SCREEN. Discard used filter paper and make sure filter
reservoir, filter screen and filter paper holder are clean and dry.
3. Install FILTER SCREEN in reservoir with spring clip on screen
pressed firmly into drain hole, and aligned parallel to sides of
reservoir. See diagram, page 9.
4. Place a NEW SHEET of filter paper on reservoir, with edges of
the paper evenly overhanging reservoir flanges.
5. Center FILTER PAPER HOLDER over filter paper, then press
firmly into reservoir. Make sure filter paper holder rests firmly on
reservoir bottom, with paper protruding evenly up all sides.
6. Inspect O-RING on FILTER SUCTION TUBE for damage.
Replace o-ring if it is scuffed, cut or cracked. Spare o-rings are
stored midway on the top portion of the suction tube.
7. Install filter reservoir assembly into fryer. Make sure o-ring
closest to end of suction tube is firmly seated in SUCTION LINE
RECEPTACLE.
IMPORTANT:
Replace filter paper after each
day’s filtration, or as needed to
return oil promptly to kettle.
IMPORTANT:
Crumbs and other debris left in
the filter reservoir can prevent
filter paper from sealing to
bottom of reservoir completely.
This will cause incomplete
filtration.
WARNING: BURN HAZARD
HOT OIL SPILL OR SPLATTER
DO NOT REMOVE FILTER RESERVOIR WHEN IT CONTAINS HOT OIL
PROTECTIVE CLOTHING AND GLOVES MUST BE WORN
DURING THE FILTERING PROCESS
HOT OIL WILL CAUSE SEVERE BURNS ON CONTACT
Death or serious injury may result from contact with, or slipping and falling in, spilled oil.
WARNING
WARNING: BURN HAZARD
DO NOT REMOVE FILTER RESERVOIR IF IT IS HOT
WEAR PROTECTIVE GLOVES OR
ALLOW RESERVOIR TO COOL BEFORE REMOVING
Oil will rapidly heat the reservoir. Serious burns can result
from touching the filter reservoir with bare hands.
WARNING
361 2M-301669 Owners Manual WFAE-30F Free-Standing 30# Electric Fryer