Specifications

FILTERS INSTALLATION
FILTER PACK: Ships installed in the hood. If the FILTER PACK is not
in position, the CHECK FILTERS indicator will light.If the FILTER
PACK becomes clogged, the REPLACE FILTER PACK indicator will
glow.
To install the FILTER PACK: Position the lter pack with the charcoal
portion UP. Slide the lter pack toward the rear of the unit until it
contacts the guides on the back panel. Push the lter pack UP into
the upper opening until it rests rmly against the lter pack seal.
When up in position, holder clips can be snapped over wall ledge on
each side. To remove FILTER PACK: Grasp both holder clips and
pull INWARD until the clips clear the sidewall ledge. Then, pull the
lter pack down and out.
PRE-FILTER: The PRE-FILTER ships in the FILTER FRAME. If the
PRE-FILTER is not in position, or if the PRE-FILTER is not in the
FILTER FRAME, the CHECK FILTERS indicator will light.
If the PRE-FILTER becomes clogged, the REPLACE PRE-FILTER
indicator will glow.
T
o install the PRE-FILTER: Pay attention to the air ow markings.
The AIR FLOW arrow will point away from the installer. Slide the
assembly up into the front opening, behind the upper lter rail.
While pressing slightly against the bottom of the assembly, pull the
FILTER HANDLE toward you so as to engage the FILTER HOOK
over the lip of the top lter rail. Then lower and seat the assembly
into the top indentation of the lower lter rail.
GREASE BAFFLE: If the GREASE BAFFLE is not in place, the
CHECK
FILTERS indicator will glow.
To install the GREASE BAFFLE: Slide the grease bafe up into
the indentation of the upper lter rail, then lower and seat it into the
bottom indentation of the lower lter rail. Pull toward you and
downward to verify the GREASE BAFFLE is properly seated in the
lower frame rail.
NOTE:
The GREASE BAFFLE
and FILTER PACK activate
mechanical switches, and
the PRE-FILTER activates
a vacuum switch, to verify
that the lter elements are
in their proper positions.
All lter elements must be
properly installed or the
cooktop will not be
energized. Also, the
CHECK FILTERS indicator
will light.
IMPORTANT:
The lter hook prevents
the PRE
-FILTER
from being drawn in
during operation. After
installation, press against
the top of the lter frame to
verify proper engagement
of the lter hook over the
lip of the top lter rail.
Use only genuine Wells
parts and lters, call
[phone] or your
authorized Wells service
agent. Parts supplied
by others will void your
warranty and may not
provide safe operation.
INSTALLATION (continued)
FILTER
RAIL
FILTER
HOOK
FILTER PACK
PRE-FILTER
ASSEMBLY
GREASE
BAFFLE
GREASE
TROUGH
GREASE
CUP
AIR FLOW
HOLDER CLIP
FILTER PACK
POSITION
SWITCH
GREASE BAFFLE
POSITION
SWITCH
FILTER PACK
SEAL
PRE-FILTER
NOTE: AIR FLOW ARROW
POINTS FROM
INSTALLER WHEN
PROPERLY INSTALLED
AWAY
FILTER
FRAME
AIR FLOW
NOTE: PRE-FILTER IS SENSED
AS BEING IN POSITION BY THE
PRESSURE DROP ACROSS IT.
FILTER HOOK
FILTER
HANDLE
FILTER PACK
SEAL
HOLDER CLIP
CLIPS ONTO
LEDGE
WALL OF UNIT
PRE-FILTER
IL2147
Fig. 7 Filter Installation
11
M506 2M-304964 Owners Manual WVOC-4H M506 2M-304964 Owners Manual WVOC-4H