Owner`s manual

3. With the engine in a level position, fill to the outer edge of the oil filler hole with the

recommended oil.

4. Screw in the filler cap/dipstick securely.

ENGINE OIL RECOMMENDATIONS

• Oil is a major factor affecting performance and service life. Use 4-stroke

automotive detergent oil.

• SAE 10W-30 is recommended for general use. Other viscosities shown in the

chart may be used when the average temperature in your area is within the

recommended range.

• The SAE oil viscosity and service classification are in the API label on the oil

container. We recommend that you use API SERVICE Category SE or SF oil.

SAE Viscosity Grades

-20 0 20 40 60 80 100°F

L 2 I _ L ,J J !

-30 -20 -i0 0 10 28 30 40°C

AMBEENT TEMPERATURE

Figure 17- Oil Recommendations

Air Filter Maintenance

Remove the air cleaner cover and inspect the filter. Clean or replace dirty filter elements.

Always replace damaged filter elements.

A dirty air filter will restrict air flow to the carburetor, reducing engine performance.

If you operate the engine in very dusty areas, clean the air filter more often than specified

in the MAINTENANCE SCHEDULE.

NOTE: Operating the engine without an air filter, or with a damaged air filter, will allow

dirt to enter the engine, causing rapid engine wear. This type of damage is not covered by

Limited Warranty.

To service the air filter, perform the following steps:

1. Remove the wing nut from the air cleaner cover, and remove the air cleaner cover.