Use and Care Manual

WARNING! To avoid injury from accidental startups, make sure that the power trigger lock is engaged and

the battery is removed from the jigsaw.

ASSEMBLY & ADJUSTMENTS

INSTALLING AND REMOVING THE BLADE

1. Rotate the blade clamp lock (Fig. 1 - 1) counterclockwise to loosen

the blade. Hold the lock in the open position.

2. Insert the new blade with teeth facing forward between the blade

clamp and the front wire guide.

3. Close the blade clamp lock.

Fig. 1

WARNING! Always use sharp blades for the best results. DO

NOT use blades that are bent, deformed, or damaged.

INSTALLING THE STRAIGHT GUIDE

1. Loosen the two straight guide lock knobs (Fig. 2 - 1).

2. Place the straight guide through the two slots below the lock knobs

(Fig. 2 - 2)

3. Adjust the straight guide to your desired width and secure in place

by retightening the lock knobs.

INSTALLING THE DUST GUARD

1. Secure the dust guard to the front of the saw by snapping it into

the slots on either side of the saw as shown in Fig. 3.

INSTALLING THE DUST PORT

1. Secure the dust port (Fig. 4 - 1) to the back of the saw using the

snap-ﬁt locking tab. The dust port is 1.4 in. (35mm) in diameter.

Fig. 2

Fig. 3

Fig. 4