Use and Care Manual

OPERATION

STARTING THE JIGSAW

1. Push the trigger lock (Fig. 5 - 1) to the left or right to unlock the

power trigger. NOTE: The jigsaw will not start if the trigger lock is in

the center position.

2. Pull the power trigger (Fig. 5 - 2) to start the saw. The LED light on

the front of the saw will illuminate.

3. To increase the speed of the saw, apply more pressure to the pow-

er trigger. To decrease the speed of the saw, apply less pressure to

the power trigger.

STOPPING THE JIGSAW

1. Release the power trigger. The LED light on the front of the saw

will turn off.

2. Return the trigger lock to the middle position to lock the saw.

3. Remove the battery when storing the tool to avoid accidental start

ups.

SETTING THE BLADE ORBIT

Use the blade orbit selector dial (Fig. 6 - 1) to set the correct blade

orbit for your operation. Refer to the chart below for setting the blade

orbit:

Fig. 5

Fig. 6

Setting 0 - Hard materials such as metals or thin sheet

metals. This setting can be used with knife blades, grit

edge blades, rasp work, and down cutting blades. This

setting can also be used for round cuts.

Setting 1 - Soft materials where cleaner cutting or

delicate scrolling work is performed.

Setting 2 - Medium density materials such as harder

woods or particle board.

Setting 3 - Soft materials such as wood, plastic, etc.

This setting can be used when fast cutting is more

important than a clean cut.