Product Manual











 

 

  





















PAGE 1
PAGE 2
Specifications Input power: Power supply: No-load speed: Engraving tip: Weight: 13W 120V, 60 Hz 7,200 SPM (stroke per minute) Tungsten Carbide Tipped Steel 12 oz Includes Engraver, Tungsten carbide tip, 2 pieces Stencils, Allen wrench, instruction manual. Safety instructions Safety is a combination of common sense, staying alert, and knowing how your engraver works. SAVE THESE SAFETY INSTRUCTIONS. 1. READ and become familiar with this entire instruction manual.
PAGE 3
Installing an engraver tip WARNING: Disconnect the engraver from the power supply before making any adjustments or maintenance procedures. 1. Loosen the tip release screw by turning it counterclockwise with the included Allen wrench. 2. To fit the new engraving tip, insert the tip through the center of the hole of the engraver, ensuring the tip fully enters the housing. A new tip should protrude from the end of the housing by approximately 8.5mm. 3.
PAGE 4
One (1) Year Limited Warranty ® WEN is committed to building tools that are dependable for years. Our warranties are consistent with our commitment and dedication to quality. ONE (1) YEAR LIMITED WARRANTY OF WEN PRODUCTS FOR HOME USE. GREAT LAKES TECHNOLOGIES, LLC (“Seller") warrants to the original purchaser only, that all WEN consumer power tools will be free from defects in material or workmanship for a period of one (1) year from date of purchase.