Use and Care Manual

KNOW YOUR ROTARY TOOL & ACCESSORIES
No. Accessory Explanation & Applications
1 Collet (Ø1/8)
Installs onto the tool's spindle for holding a rotary tool bit in place. Your tool
comes with one Ø1/8"collet. The shank diameter of the rotary tool bit must
match the size of the collet.
2 2-in-1 Wrench
• Use the front of the wrench for loosening/tightening the collet nut to re-
move/install rotary tool bits or to change collets.
• Use the back of the wrench for adjusting the screw on the Sanding Drum
Mandrel and Disc Mandrel (see page 12).
3
Sanding Drum Mandrel
(Ø1/8")
A mandrel with a cylinder-shaped rubber tip for attaching sanding bands. Can
be expanded or retracted using the back of the Wrench (see page 12).
4 Sanding Band
Slides over the top of the No. 3 sanding drum mandrel to sand and smooth
around surfaces and inside curves. NOTE: Replace the sanding bands when
the grits are worn down.
5
Disc Mandrel
(Ø1/8")
A mandrel with a threaded head and slotted cap for attaching wheel/disc ac-
cessories (see page 12).
6 Cutting Disc
Thin disc used for cutting or slicing work on metal, wood and ceramics. Cut
off bolt ends or make slots in stripped screws. Only cut along the wheel's
edge; DO NOT use for sanding or cutting curves.
Attach to No. 5 Disc Mandrel (see page 12).
7
Felt Accessory Mandrel
(Ø1/8")
A mandrel with a screw head for attaching felt polishing accessories (see
page 12).
8 Felt Polishing Wheel
Screws onto the top of the screw mandrel to clean, polish and buff metal,
wood and plastics to a smooth and bright finish. Do not use at speeds higher
than 15,000 RPM.
Attach to No. 7 Screw Mandrel (see page 12).
9
Nylon Wire Brush
(Ø1/8")
For general cleaning and polishing purposes.
NOTE: Excessive pressure can damage the wires. Operate with light pressure
and let the tips of the wire brush do the work.
10
HSS Cutter Bit
(Ø1/8")
Use for edge cutting, carving and creating slots and holes in plastics, wood
and metals.
11
Grinding Stone Bit
(Ø1/8")
Use for various grinding applications including sharpening blades and tools,
removing flash from metal castings, deburring metal after cutting, smoothing
welded joints, grinding off rivets and removing rust.
12
Diamond Coated Bit
(Ø1/8")
For cutting and engraving in wood, plastics, and soft metals such as alumi-
num, copper, and brass.
13 HSS Drill Bit (Ø1/8")
Drills into materials such as metal, hardwood, and plastics.
Compatible Rotary Tool Accessories Kits: 150-Piece (Model 230151A), 282-Piece (Model 230282A),
320-Piece (Model 230321A), 327-Piece (Model 230327A), available for purchase at wenproducts.com.
11