Use and Care Manual

CHARGING THE TOOL (FIG. 4)

THE BATTERY TOOL MUST BE CHARGED BEFORE FIRST USE. A battery

pack that has never been charged, or has not been used for an extended

period of time must be charged completely before using.

NOTE: The battery pack requires approximately 3 to 5 complete charging

and draining cycles before it can reach its full potential.

To charge the tool:

1. Charge your tool in a well-ventilated area and away from any ﬂamma-

ble materials. Connect the power plug of the charger to a matching wall

receptacle (AC 100-240V, 50/60Hz). Insert the other end of the charger

into the charging port on the back of the rotary tool (Fig. 4 - 1).

PREPARATION & ASSEMBLY

WARNING:

Do not use the tool while charging!

Fig. 4

Fig. 5

INSTALLING ROTARY TOOL BITS (FIG. 5)

1. Make sure the tool is OFF.

2. Hold down the spindle lock button and rotate the collet nut

until the spindle lock engages.

3. Using the included wrench, loosen and remove the collet nut

by turning it counterclockwise. Release the spindle lock button.

4. One 1/8" collet is pre-installed inside the tool. The shank of

the rotary tool bit must match the collet size. Fully insert the

suitable rotary bit into the spindle hole through the collet nut

and collet.

5. Press down the spindle lock button and fully tighten the col-

let nut using the included wrench. Pull on the rotary tool bit to

check that it is ﬁrmly secured inside the tool.

Spindle Lock Button

Collet Nut (with collet inside)

WARNING:

Check to make sure that all accessories are assembled correctly and securely on the

rotary tool. Do not use if any accessory or part is loose or damaged.

2. The red battery charging light (Fig. 4 - 2) on the tool's control panel will turn red to show that the tool is

charging. Charge for 2-3 hours, or until indicator light turns yellow, and your tool is ready for use.

3. Unplug the charger from the tool and store it inside the carrying case. Do not overcharge batteries.