Use and Care Manual

OPERATION
STALL PROTECTION
This tool has a built-in stall protection feature to protect the motor and battery in the event of a stall. If the
tool is stalled for too long or the accessory is bind in the workpiece, especially at high speeds, the tool will
automatically turn off.
When this happens, simply take the tool out of the workpiece, press the power button to turn it OFF and wait
for 3 seconds. Then you can turn the tool back on to continue operation.
LOW BATTERY-POWER PROTECTION
When the battery is almost fully drained, the tool may shut down automatically more frequently than normal
to indicate low power. If this happens, it is time to recharge the battery.
OPERATION
1. Inspect the rotary tool and accessories for any damage before use. Immediately discard any accessories
with bent shafts or any other damage. Make sure that the ventilation slots on the tool are not obstructed,
otherwise the motor may overheat.
2. Turn ON the tool and adjust to the desired speed. Slowly lower the accessory bit onto the workpiece and
guide the tool with light, even pressure.
NOTE: Best results are achieved by an even speed and pressure. Do not exert excessive pressure on your tool
as it may damage your workpiece and the accessory bit. Let the tool do the work. For better results, you can
make several progressive passes until the desired cutting depth or finish is achieved.
3. When the operation is complete, lift the tool away from the workpiece and turn it OFF. Do not touch the
rotary accessory or workpiece immediately after operation as they can be very hot. Follow the instructions on
the next page for properly maintaining your tool and accessories.
WARNING: Be alert for batteries that are nearing their end of life. If you notice decreased tool
performance or significantly shorter running time between charges, the battery may have reach the end
of its lifetime. Contact our customer service at [phone], M-F 8-5 CST or email techsupport@
wenproducts.com for support with battery replacement.