Product Manual

ASSEMBLY & ADJUSTMENTS

ASSEMBLING THE OUTRIGGER SET

1. Assemble the scaffolding (model 31110T, sold separately), one or

two frames high, by following the user manual.

NOTE: Always use outrigger and guardrails when stacking frames and

never stack more than two units.

2. Install the caster (Fig. 1 - 1) into the outrigger (Fig. 1 - 2) using a

locking pin (Fig. 1 - 3). Make sure that it is secure and set the caster

brake. Repeat this step for the other three casters.

3. Place the outrigger at the base of the scaffolding frame at a 90°

angle to the side brace (Fig. 2).

4. Lock the outrigger (Fig. 2 - 1) into place by using two locking pins

(Fig. 2 - 2). If you use scaffolding with casters, you must ﬁrst remove

the locking pins from the casters to attach the outrigger set. Once the

outrigger is attached, replace the locking pins to lock the casters and

outriggers to the scaffolding.

5. Firmly tighten the tightening knob (Fig. 2 - 3) so that the scaffolding

and the outrigger are perfectly lined up and secure.

Fig. 1

Fig. 2