Use and Care Manual

INSTALLING/REMOVING THE FACE PLATE

1. Mount the face plate (Fig. 4 - 3) onto the spindle by screwing

it clockwise as far as it will go onto the spindle threads.

2. Insert the knockout rod (Fig. 4 - 1) into the hole to lock the

spindle and use the wrench (Fig. 4 - 2) to fully tighten the face

plate.

To remove the face plate, insert the knockout rod into the hole

and use the wrench to loosen the face plate.

INSTALLING THE SPUR CENTER

1. Make sure the mating surfaces of both the spur center and

the headstock spindle are clean. If they are not, the center will

not seat properly in the spindle.

2. Drive the spur center (Fig. 5 - 1) into the workpiece (Fig. 5 -

2) using a rubber mallet or a piece of scrap wood.

3. Push the spur center into the spindle.

REMOVING THE SPUR CENTER

The workpiece can be mounted between the spur center and

live center, or it can be mounted onto the face plate. Remove

the spur center before mounting workpiece onto the face plate.

1. Hold the spur center (Fig. 6 - 2) to prevent it from falling. Use

a rag to protect your hand from the sharp edges.

2. Insert the knockout rod (Fig. 6 - 1) through the spindle hole

to tap out the spur center (Fig. 6 - 2).

INSTALLING THE LIVE CENTER

1. Rotate the tailstock handwheel (Fig. 7 - 3) clockwise a few

times to advance the quill (Fig. 7 - 2) forward.

2. Make sure the surfaces of both the spur center and the quill

are clean. If they are not, the center will not seat properly in the

quill.

3. Push the live center (Fig. 7 - 1) into the quill.

1 2

NOTE: It is not necessary to remove the face plate in order

to install the spur center.

ASSEMBLY & ADJUSTMENTS

Fig. 4

Fig. 5

Fig. 6

Fig. 7