Use and Care Manual

REMOVING THE LIVE CENTER

1. Hold the live center (Fig. 8 - 1) to prevent it from falling. Use

a rag to protect your hand from the sharp edges.

2. Rotate the handwheel (Fig. 8 - 2) counterclockwise to retract

the quill until the live center is released from the quill.

INSTALLING THE ACCESSORY HOLDER

1. Position the accessory holder (Fig. 9 - 1) below the head

stock on the back of the base. Align the holes and secure the

accessory holder using two M5x12 pan head screws

(Fig. 9 - 2). Tighten the screws using the 3 mm hex wrench.

You can organize your wrench, hex wrenches, knockout rod,

live center and spur center into the accessory holder as shown

in Fig. 10.

MOUNTING THE LATHE TO A BENCHTOP

For effective and safe operation, the lathe should be mounted

to a bench table. Remove the feet and use the four threaded

holes in its base to bolt it to the surface. Place the machine

on a stable, ﬂat work surface. Make sure there is sufﬁcient

open space around the machine for operation and adjustments.

Route the power cord so that it will not make contact with the

lathe’s moving parts.

Refer to Fig. 11 for dimensions on the mounting holes of your

lathe’s base. For maximum accuracy, we advise measuring

in millimeters instead of inches. The threaded holes on the

lathe’s base are M8-1.25. Mounting hardware is not included.

737mm

165mm

756mm

185mm

M8-1.25

737 mm (29.02 in.)

755.5 mm (29.75 in.)

165 mm 184 mm

(6.50 in.) (7.25 in.)

ASSEMBLY & ADJUSTMENTS

Fig. 8

Fig. 9

Fig. 10

Fig. 11