Use and Care Manual

ASSEMBLY & ADJUSTMENTS
10
Before using the wood lathe, you must assemble the unit using the instructions in this section. Check
your packing list against the diagram below. If any part is damaged or missing, please contact our cus-
tomer service at [phone], M-F 8-5 CST or email us at [e-mail].
WARNING: Do not plug in or turn on the tool until it is fully assembled according to the in-
structions. Failure to follow the safety instructions may result in serious personal injury.
PACKING LIST
A. Lathe
B. Tool Rest
C. Tailstock Handle
D. Handle Screw with Rubber Ring
E. Face Plate
F. Knockout Rod
G. Wrench
H. MT2 Live Center
I. MT2 Spur Center
J. Accessory Holder
K. 5 mm Hex Wrench
L. 3 mm Hex Wrench
The tools listed below are not included
but are required for either assembly
or adjustment.
• Flathead Screwdriver
A
B
C
D
E
F
G
J
K
L
I
H