Use and Care Manual

ASSEMBLY & ADJUSTMENTS

WARNING: Do not plug in or turn on the tool until it is fully assembled according on the

instructions. Failure to follow the safety instructions may result in serious personal injury.

INSTALLING THE HANDLE

Attach the handle screw (Fig. 1 - 1) through the handle (Fig. 1

- 2) hole onto the handwheel. Secure it using a flat head screw-

driver (not included).

INSTALLING THE TOOL REST

1. Loosen the locking handle (Fig. 2 - 3) and insert the tool rest

(Fig. 2 - 1) into the tool rest base (Fig. 2 - 2).

2. Adjust the tool rest height up or down to the desired position

and then tighten the locking handle (Fig. 2 - 3). The handle is

spring-loaded and can be re-positioned as necessary by pulling

outwards, repositioning the lever, and allowing it to spring back

inwards.

REMOVING THE ANTI-RUST GREASE

The lathe bed and centers have been coated with grease to prevent them from rusting.

1. Remove the excess oil and grease by wiping it off with a clean cloth.

2. Remove any residue with a rag moistened with acetone, kerosene, or other removal agent. Wear

gloves to protect your skin. Do not use gasoline, or cellulose-based solvents such as paint thinner or

lacquer thinner, as these will damage the painted surfaces.

3. Apply a light coat of good-quality paste wax to the surfaces to guard against rust and corrosion.

Fig. 1

Fig. 2