Product Manual

REPLACING THE COLLECTION BAG
Empty the collection bag on a regular basis. This will allow the machine to operate at its maximum efficiency.
Replacement collection bags can be purchased from wenproducts.com by searching the part number 3403-036.
WARNING: Always wear the appropriate respirator or dust mask and safety glasses when emptying the
collection bags. Small dust particles can escape, causing them to become airborne and easily inhaled. This
microscopic airborne dust is extremely unhealthy to breathe and can cause health problems.
1. Disconnect the machine from the power outlet. Make sure you are wearing a respirator or dust mask, and safety
glasses.
2. Release the belt clamp securing the collection bag, then remove the bag from the collector.
3. Securely close the top of the bag and safely dispose of it according to local and federal standards.
4. Install a new collection bag.
10
OPERATION
1. Connect the dust collector to your woodworking machine using a 4-inch dust collection hose (not included).
Adaptors may be needed depending the dust port size of your machine.
2. When starting the machine, the amperage may spike up to 80 amps for a short moment and this can risk tripping
the electrical circuit. Be sure to both inlet ports are covered before starting the machine. The least amount of power
will be drawn when there is no air flow.
3. Make sure the dust collector switch is turned off and insert the power plug into a matching receptacle. Then,
switch on the dust collector and start operating your woodworking machine.
WARNING: To prevent serious injury, make sure all the warnings and instructions have been read and
understood before operating this tool.
WARNING: Wear appropriate respirator or dust mask and safety glasses when operating the machine.
Small dust particles can escape from the filter bag, causing them to become airborne and easily inhaled.
This microscopic airborne dust is extremely unhealthy to breathe and can cause health problems.