Product Manual

ASSEMBLY

Place the base plate (D) upside down on a flat sur-

face. Install the 4 casters in the following configuration:

M6x10 Phillips screw, M6 washer, base plate, caster (J)

and M6 nut. Tighten the nuts and make sure all casters

are properly installed and can swivel freely.

Position the outlet gasket (I) on top of the motor as-

sembly and align the holes as shown. Place the out-

let (L) over the gasket and secure it with M6x20 hex

screws, M6 washers and M6 Nuts.

Mount the three lower bag support poles (F) to the

base in the configuration as shown. Secure the poles

with M8x16 hex screws and M8 washers.

Turn the base (D) over and align the motor assembly

(B) with the holes on the base as shown. Secure the

motor assembly using M8x16 hex screws, M8 washers

and M8 nuts.

WARNING: Do not attempt to plug in or operate your tool until the entire operator’s manual has been

read and understood. Failure to do so could result in personal injury and damage to the tool.

1. ASSEMBLING THE CASTERS

3. INSTALLING THE OUTLET 4. INSTALLING THE SUPPORT POLES

2. ATTACHING THE MOTOR ASSEMBLY

Fig. 1 Fig. 2

Fig. 3a

Fig. 4

Fig. 3b