Product Manual

8
ASSEMBLY
Mount the collector (C) onto the two poles in the
front as shown. Make sure that the side port of the
collector is facing the motor assembly to prepare it for
hose connection in Step 7. Secure them with M8x16
hex screws and M8 washers.
The upper bag support pole (E) will be installed in the
position overlapping the third bottom pole as shown.
Secure both poles onto the collector using M8x16 hex
screws and M8 washers.
5. ASSEMBLING THE COLLECTOR
7. CONNECTING THE HOSE
6. INSTALL THE UPPER SUPPORT POLE
8. INSTALLING THE INLET CONNECTOR
Attach one end of the hose (A) to the motor assembly
outlet and attach the other end to the collector outlet.
Secure the two ends of the hose with the hose clamps
(M) as shown.
Attach the inlet connector (G) onto the inlet port of
the motor assembly. Align the hole on the connector
with the hole on the top of the inlet port and secure
using a cap screw.
Fig. 5
Fig. 6
Fig. 7
Fig. 8