Use and Care Manual

ASSEMBLY

INSTALLING BED EXTENSION (FIG. K)

(SOLD SEPARATELY)

The WEN 3427EX1 Wood Lathe Bed Extension is an

optional accessory that can be purchased separately

to extend the maximum length of the lathe’s capacity

from 15.75 inches to 39.4 inches.

1. Fit the bed extension (Fig. K - 3) to the bed using four

socket head screws and four flat washers.

2. Remove the end stop screw (Fig. K - 2) from the bed

and assemble it onto the bed extension.

3. Make sure the tail stock (Fig. K - 1) slides freely

across the connection point.

Fig. J

Fig. L

TOOL RACK (FIG. L)

There is a tool rack (Fig. L - 1) on the back of the head. The wrench, knockout rod and spur center can be placed

into this as needed.

MOUNTING THE LATHE TO A BENCHTOP

For effective and safe operation, the lathe should be mounted to a bench table, removing the feet and using the

four threaded holes in its base to bolt it to the surface.

Fig. K