User Manual

Assembly and adjustments

Unpacking

Carefully unpack the band saw and all its parts, and compare against the list below. Do not

discard the carton or any packaging until the band saw is completely assembled.

WARNING: If any part is missing or damaged, do not plug in the band saw until the

missing or damaged part is replaced.

A Band Saw (1) H Short Support Plate (2) P Screw M6x12 (4)

B Table Insert (1) J Long Support Plate (2) Q Bolt (16)

C Table (1) K Wrench (1) R Flat Washer 8 (20)

D Miter Gauge (1) L Combination Wrench (1) S Nut 8 (16)

E Fence (1) M Rail Lock Knob (4) T Nut 6 (1)

F Rail Guide (1) N Rubber Foot (4) U Lock Washer (4)

G Stand Leg (4) O Screw M6x32 (1)

Tools Required for Assembly & Adjustments

The tools listed below are not included but are required for assembly.

2 14mm Open End Wrench

1 Cross Point Screw Driver

1 Combination Square