Installation Instructions

WEN 3920/3921 Two-Direction 16-Inch Variable Speed

Scroll Saw

LED Lamp Replacement

Tools Needed:

Wire Cutter/Wire Stripper

Pliers

Phillips Head Screw Driver

(WEN 49036 Cordless Screwdriver shown)

Replacement Loc-line LED Assembly

IDC Connectors (26 - 22AWG)

Safety first

1. Remove yellow switch lock from on/off switch.

2. Unplug scroll saw from power source

PAGE 1
WEN 3920/3921 Two-Direction 16-Inch Variable Speed Scroll Saw LED Lamp Replacement Tools Needed: Wire Cutter/Wire Stripper Pliers Phillips Head Screw Driver (WEN 49036 Cordless Screwdriver shown) Replacement Loc-line LED Assembly IDC Connectors (26 - 22AWG) Safety first 1. Remove yellow switch lock from on/off switch. 2.
PAGE 2
Steps Use the pliers to remove the tip of the black Loc-line from LED Assembly from your saw. Cut the LED Lamp off at the end of the Loc-line assembly. Remove the two Phillips head screws on the snap flex assembly from the upper arm of the saw. Pull the Loc-line tube off leaving the wire leads on the saw. Cut and strip the wire leads about 2 inches from the upper arm.