Use and Care Manual

Assembly and adjustments (continued)

Tools needed for assembly

• Adjustable wrench

• Phillips® screwdriver

• Hammer and block of wood

Base to column (Fig. 3)

1. Set the base (1) on the floor.

2. Place the column tube (2) on the base (1), align the

column support holes with the base holes.

3. Install a bolt (3) in each column support hole and tighten

with the wrench.

Table to column (Fig. 4–7)

1. Loosen set screw (2) in rack collar (1) and remove the collar.

2. Remove the rack (3) from the column (4).

3. Insert worm shaft (5) into the hole of the table support

crank handle (6) from inside the table support. The worm

shaft (5) should extend outside the housing about 1” (25

mm).

4. Insert the rack (3) into the geared groove of the table

support (6). Make sure the worm shaft (5) on the inside of

the table support is engaged with the teeth of the rack. The

table support should sit at the center of the rack.

5. Slide the table support and rack assembly (3, 5, and 6)

down together onto the column. Insert the bottom edge of

the rack into the lip (7) of the column support. Hold in this

position until step 6 is completed.